If you use Verity Someone loves Boating or goes out on the water Often, there is a high chance That You Need to Learn How to connect the trolling motor to the battery. Famous for trolling motors are from not * Their outstanding features are adjustable and help the boat in maneuverability. Most of the time, I do not People Know How to connect the cable to the battery motor sing this fortified, be used on the boat and this Leads to a less fun Experience on the water.
For the Correct procedure to follow, Some Specific tools are needed. You Need a trolling motor That Includes remote control and manual control filler. You must have batteries Been That I have chosen ACCORDING to the Needs of your boat. It is possible, to another one or more batteries connected in parallel or in series. To secure the motor power cables with the battery, the ends of the terminals are required. In Case of high voltage batteries connected Together, a jumper ar required. A circuit breaker should be used for protection, Along with a trolling motor boat Which aids in a quick Disconnect with the motor boat. The trolling motor is easily. removed via a quick release plate. May be required wiring Extension of May there be more than one battery to connect and the jumper wire May not be sufficient. Ar You Need Some power cords.
How to Choose the right battery?
- There are two Types of batteries are used for trolling That motors. The first is the absorbed glass mat battery, commonly Known for AGM, and the other is a wet cell lead. AGM batteries are durable and Vibration resistant, Which Makes Them survive for ship time. They also conduct work for four years unlike the typical battery dies Which After two years. If you EXCEPTIONAL I want performance, AGM batteries are the safest solution, however, is very expensive and are not * May overwhelm your budget.
A wet cell lead as Acceptable in terms of operation for the engine. It sing withstand pressure and is Cheaper than AGMs. However, I do not * Could Cause a cargo ship and leaks. They will not be resistant to Vibration, That Which means that required maintenance is very high.
- The battery (or batteries connected in series by a jumper) Been shouldnt i have used before. First Take Which wasnt the red wire made of lead, from the outboard motor and connect it to That Which is Positive battery terminal. Then Take the black wire and connect it to the negative battery terminal. Just remember fortified black wire is connected to the black terminal and the red wire is connected to the red terminal. It is Recommended to Use a 50 amp circuit breaker in the middle.
- If a there is a 12V battery, this only processes.we most needed. If a hot engine is 24 volt and two 12 volt batteries are Included, Take the black lead from the engine and connect it to the negative terminal of the battery first. Then Take the red lead from the engine and connect it to the Positive terminal of the second battery. Then Use a jumper to connect the Positive terminal of the first battery to the negative terminal of the second battery. You Need to Use a 40 amp circuit breaker for this.
If the motor is 36 volts, you need three 12V batteries. This process is a bit complicated but once you understand it, you can do it without any problem. Connect the black lead from the motor to the negative terminal of the first battery. Then connect the red lead from the motor to the positive terminal of the third battery. After this you need two sweaters. Connect one from the positive terminal of the first battery to the negative terminal of the second battery. Use another jumper to connect the positive terminal of the second battery to the negative terminal of the third battery. You will eventually have a 36V motor.
For more related blogs please click here